LUNT O-ring 34mm for Pressure-Tuner at MT & THa solar telescopes

Spare part for Pressure-Tuner of MT and THa series H-alpha solar telescopes from LUNT SOLAR SYSTEMS

Two rubber O-rings are installed into the Pressure-Tuner of Lunt Solar Systems solar telescopes to seal the air-pressure tuning system. Over time, the rubber of this O-rings can age and become porous, whereby the air-pressure can then no longer be maintained. When this happens, a old O-ring can be replaced by this spare part. The replacement is simple and can be done by the user. Installation instructions can be found here under the tab "Manuals" as a PDF file for download.

Please be sure to note:
Depending on the production series, the diameters of the Pressure-Tuner pistons can vary slightly. There are pistons for O-rings with 32mm inner diameter and 40mm outer diameter, and pistons for O-rings with 34mm inner diameter and 42mm outer diameter. Please check the diameter of your old O-rings, this spare part is an O-ring with 34mm inner diameter and 42mm outer diameter.
If you need the smaller O-ring with 32mm inner diameter and 40mm outer diameter, this is the spare part with item number 0558330.
The LS50THa telescopes have Pressure-Tuners with smaller diameters, for these you will need replacement O-rings with item number 0558320.

After replacing a O-ring, the piston and cylinder of the Pressure-Tuner can be re-greased with grease available under item number 0558350.

FEATURES

• Inner diameter: 34mm
• Outer diameter: 42mm
• Cannot be used separately, only as a replacement part on the Pressure-Tuner of MT and THa telescopes from Lunt Solar Systems.
• It does not matter what blocking-filter is at the MT or THa telescope.

SCOPE OF DELIVERY

• Spare part one O-ring with 34mm inner diameter and 42mm outer diameter for Pressure-Tuner of MT and THa H-alpha solar telescopes from Lunt Solar Systems